Boiler heating element for two-group Rancilio machines, with 230 mm of heated length under the flange, a seat for one probe and faston terminals. It is built for a 230/380 V supply, according to the wiring installed on the machine. A direct replacement for an element that is burnt out or scaled up, restoring the boiler's normal recovery time.
It is intended for two-group Rancilio boilers. Before ordering, read the rating plate on the current element and confirm the stated power, the supply voltage and the 230 mm heated length.
What does 230/380 V mean?
It means the element accepts a single-phase or three-phase supply, depending on how the elements are wired at the machine terminal block. The wiring must follow the machine's electrical diagram.
What is the heated length under the flange?
It is the section immersed in water, measured from the flange. Those 230 mm decide whether the element fits the boiler and heats the right volume — always the figure to confirm.
Which symptoms mean it should be replaced?
A heat-up time far longer than usual, steam that never recovers between shots, a breaker tripping when the element switches on, or no electrical continuity when measured.
How do I order?
Send us the power marked on the element, the voltage and the heated length through Request a quote: we will confirm the right version, with availability and lead time. We ship from Portugal to the whole of Europe.
All brand names are registered trademarks of their respective owners and are used solely to indicate part compatibility. ESPRESSOTECHNIC is not an authorised representative of these brands unless expressly stated otherwise.
