La Cimbali and Faema E98 steam and water tap — 120° angle
Part no. ET-100310
Mechanical steam and hot-water tap with a 120° angled body, a 1/4″ male ogive inlet and a 3/8″ male outlet. The sealing seat is stainless steel, which keeps the sealing face smooth on the most-used handle behind the bar. Listed for La Cimbali (Junior, M15 to M39), Faema (E64, E66, E98) and Casadio Quindici.
It will, provided the tap body is the 120° version. The part is listed for La Cimbali Junior, M15, M20, M21, M22, M25, M28, M29, M30, M31, M32 and M39, for Faema E64, E66 and E98, and for Casadio Quindici. If in doubt, send us the machine model and a photograph of the fitted tap.
What connections and angle does this tap have?
A 1/4″ male ogive inlet, a 3/8″ male outlet and a body angled at 120°. The angle has to match the machine's panel layout, so confirm the orientation of the tap being replaced before ordering the part.
What is the valve seat made of?
The sealing seat is stainless steel, which stands up to steam and scale and keeps its smooth face far longer than a soft brass seat. The remaining measurements are listed in the specification table on this page.
When should the whole tap be replaced instead of just the seals?
If the tap drips with the handle closed, or only seals when forced tight, the seat and stem are already scored and a seal kit will last only weeks. Replace the complete assembly in that case, always with the machine switched off and the boiler cold and depressurised.
How do I order this part and where do you ship?
Use the form on this page to request a quote, stating the machine brand, the model and the quantity you need. We ship to Portugal and throughout Europe.
All brand names are registered trademarks of their respective owners and are used solely to indicate part compatibility. ESPRESSOTECHNIC is not an authorised representative of these brands unless expressly stated otherwise.
